Good Deeds Estimator
Good Deeds Painting & Renovating Inc. — sign in to continue
Good Deeds Painting & Renovating Inc. — sign in to continue
| Deposit (1/3, due at signing) | $0.00 |
| Progress Payment (1/3) | $0.00 |
| Due Upon Completion (1/3) | $0.00 |
By signing below, you agree to the scope of work and payment terms above.
Or, if that's easier on your device, type your full name instead:
Signed by on
Generates a clean, client-facing summary — no internal rates, hours, or cost breakdowns, just the scope of work and the total price. You'll get a link to open on the client's device (or your own) for them to review and sign.
Proposal created!
Send this link to the client, or open it yourself on their device right now:
These default rates were pulled from your interior pricing worksheet and confirmed corrections. Paint coverage rates (sqft or linear ft per gallon) are estimates — adjust to match your actual Sherwin-Williams product coverage.
Door and window rates (in the Doors/Windows sections below) are the time for one coat of a whole item — the "Coats — Doors & Windows" setting above multiplies that up for however many coats you select, same as walls/ceilings/trim.
All window prep includes a light sand & spackle — that's standard across every frame type below, not just "Regular Frame."
Minor spot spackling and light sanding are always included in the standard wall/trim/window prep above. These are additional items beyond that baseline. * = required by law on pre-1978 housing (EPA RRP Rule).
Paint types & pricing — used to price out whatever paint product each job uses. Add as many as you need (e.g. Standard, Premium, specific product lines); pick which one applies to each paint category down in Job Totals.
Remediation hours — automatic: 3.00 hrs
Estimator's judgment — enter hours directly: hrs
Estimator's judgment — enter hours directly: hrs
Supply costs are always at the estimator's discretion — the suggestions are a starting point, not a rule. Some jobs will need more. Entering a number here updates the Estimated Total Job Cost above immediately.
Multiplied against total job hours (below) for the labor cost line in Job Costs.
Production rates from your exterior worksheet. Every number here is editable if your actual speed differs.
Uses the same "each additional coat time" percentage as the interior rates panel. Prep items are one-time tasks and aren't multiplied by coats.
Spray has its own 1st-coat and 2nd-coat rates (not the usual coats multiplier) since spraying speeds up dramatically after the first coat. Any coats beyond 2 use the 2nd-coat rate.
Caulking's "Windows" and "Door/window frames" checkboxes use these average lengths per item:
Job Setup, Clean-Up, and Special Considerations hours are entered directly in Exterior Job Totals — same as the Interior tab. Clean-Up is calculated automatically (45 min per 8 hrs of labor); Job Setup is suggested from the total job price you enter. A 4-hour minimum job floor is always applied to the exterior total automatically.
Paint types & pricing for the job are shared with the Interior tab's paint list — set prices there, pick which one applies to each category down in Exterior Job Totals.
Adds ground protection hours automatically based on total scraping hours across all sides (rate is editable in the rates panel below).
Independent from the Interior tab's labor rate — change either one without affecting the other.
Supply costs are always at the estimator's discretion — the suggestions are a starting point, not a rule. Some jobs will need more. Entering a number here updates the Estimated Total Job Cost above immediately.
Sets Siding, Soffit/Fascia, Windows/Doors/Door Frames, and Add-On coats all at once. You can still fine-tune any of those individually in the rates panel afterward.
Direct entry — anything unusual about this job that needs extra time (height, access, condition, etc.).